Welcome

WELCOME


Welcome to the blog for our campervan build

This project began in May 2020 during the 'lockdown' in the UK due to COVID-19. We were supposed to be touring Europe in our existing camper conversion 'Movano The Van Hoe' but this obviously wasn't going to be possible... So after finishing a pretty ambitious Hot Tub Trailer build (see the blog here) we decided we needed another project to keep us occupied during however many weeks left of lockdown.

We put Movano The Van Hoe up for sale and bought a Renault Master which we will convert over the coming weeks/months.

We are fortunate in that Elliot has a fully equipped workshop with tools and space to work, and we're also fortunate in that this is Elliot's second camper conversion, so we're not totally winging it!

This is a blog of the full build and I make no apologies that it is very photo heavy. The primary purpose of the blog is to document this build both for our own records, and for anyone else who's interested.

We plan on touring around Scotland with our Trailer Hot Tub when travel restrictions are relaxed enough to allow this.

Disclaimer: This is NOT meant as a tutorial. Do not try this at home. Always seek professional expert advice.

Monday, 17 August 2020

Water tank

We had a custom underslung water tank made for the van by Barratt Tanks. It sits neatly tucked up to the chassis rails in front of the rear axle and is no lower than the exhaust or fuel tank. It holds approx 100L of fresh water, and 45L of waste grey water. We also had a CBE water level sender fitted so we can keep an eye on water levels from inside the van.


You can see here how the brackets attach and clamp the tank. A strip of thin foam was added between the tank and chassis to stop any chaffing or vibration.


It is filled via a standard hoselock connector, and the waste is drained via the other tap. These were mounted tucked up high on the sill and the waste tap was cut down to aid with ground clearance as we often take the van up rough dirt tracks. Pipes were then insulated and secured.




The breather was also extended and fitted with a wee stainless filter  to stop anything crawling in. 


Also did a bit of wiring and plumbing on our secondary 10L internal fresh water system. It consists of a 12v microswitched tap connected to a Whale submersible water pump that sits in a small water carrier. ideal for a quick night away in the winter when the main system is drained down for frost, or can be used with bottled water when we have filled the the main tank from a tap we cannot guarantee is quality drinking water.


No comments:

Post a Comment